F3M-S825-1【PDF 4/4 页】SENSOR COMB 8" WAFER 25 SLOTS

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录53

1页 2页 3页 [4页]

F3M-S825-1

imensions

Unit: mm (inch)

J F3M-S825-1

Optical axis

Side mark

Thirty, (19/0.08 dia.)

vinyl-insulated,

flat bending cable

500 L x 38.1 W

Pitch: 1.27

Two,

4.2-dia.

mounting

holes

OMRON XG4E-3031

Connector

Teaching button

RUN/TEACH mode selector

Warning indicator

Teaching indicator

Power indicator

Mounting Dimensions

Two, R5

Two, M4

(1.97)

18.5 (0.71)

170 (6.69)

14 (0.55)

(3.94)

(6.30)

18.5 (0.71)

Precautions

CORRECT USETO AVOID DAMAGE

Do not use the F3M-S825-1 at a voltage that exceeds the

rated voltage range.

Do not make mistakes in wiring, such as mistakes in polarity.

Do not short-circuit the load.

Do not connect AC to the F3M-S825-1.

J INSTALLATION/ENVIRONMENT

Do NOT use the F3M-S825-1 in the following locations:

Locations exposed to direct sunlight.

Locations with high humidity that may cause condensation.

Locations with corrosive gas.

Locations where vibration or shock directly affects the

Sensor.

J CLEANING

Do not attempt to clean the F3M-S825-1 using paint thinner, to

avoid damaging the surface of the Sensor.

CONNECTION AND MOUNTING

A maximum of 24 VDC+10% can be imposed on the

F3M-S825-1. Check that the voltage of the power supply is

within the permissible range before turning on the

F3M-S825-1. The power supply must be constructed so that

the secondary circuit is insulated with an isolating

transformer.

Do not wire power lines or high-voltage lines within the

same conduit with the lines of the F3M-S825-1, or the sensor

may be damaged or malfunction.

Avoid mechanical impact when mounting the F3M-S825-1, or

its water-resistant properties will be reduced.

J POWER SUPPLY

If a standard switching power supply is connected to the

F3M-S825-1, be sure to ground the FG (frame ground) and

G (ground) terminals of the power supply. If these terminals are

not grounded, the Sensor may malfunction due to switching noise

that will be generated from the power supply.

Cat. No. D063-E3-825

7/00

Specifications subject to change without notice.

Printed in U.S.A.

OMRON ELECTRONICS, INC.

One East Commerce Drive

Schaumburg, IL 60173

NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.

1-800-55-OMRON

OMRON CANADA, INC.

885 Milner Avenue

Scarborough, Ontario M1B 5V8

416-286-6465

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式